Microscan QX-830 - Page 347

QX-830 Compact Industrial Scanner User’s Manual A-59
Appendices
Output 1 Parameters
Output On
Output State
Pulse Width
Output Mode
Output 2 Parameters
Configurable Output 3
Serial Cmd: < K810,output on ,output state,pulse width,output mode>
Default: Mismatch or No Read
Options: 0 = Mismatch or No Read
1 = Match or Good Read
2 = Mismatch
3 = No Read
4 = Trend Analysis
5 = unused
6 = Diagnostic Warning
7 = In Read Cycle
Serial Cmd:
< K810, output on, output state ,pulse width,output mode>
Default: 0 = Normally Open
Options: 0 = Normally Open 1 = Normally Closed
Serial Cmd:
< K810, output on,output state, pulse width ,output mode>
Default: 50 (50 ms)
Options: 1 to 65535 (in 1 ms increments)
Serial Cmd:
< K810, output on,output state,pulse width, output mode >
Default: 0 = Pulse
Options: 0 = Pulse
1 = Latch Mode 1 (Unlatch Input 1 Pin)
2 = Latch Mode 2 (Unlatch Opposite Condition)
3 = Latch Mode 3 (Unlatch Re-Enter Read Cycle)
Serial Cmd:
< K811, output on,output state,pulse width,output mode>
Serial Cmd: < K812, output on,output state,pulse width,output mode>