Microscan QX-830 - Power and Trigger Switching

3-8 QX-830 Compact Industrial Scanner User’s Manual
Power and Trigger Switching
Power and Trigger Switching
PWR
TRIG
1, 3,
T
1, 2,
3, T
1, 2,
3
1, 3
Power can be bussed between scanners and interface
devices. At each location on a network where a new power
supply is added, the Power switch on the QX-1 can be
used to break power between Connector 2 and Connectors
1, 3, and T.
The Trigger signal between Connector 2 and Connectors
1, 3, and T can be broken using the Trigger switch. This
isolates trigger signals as required by the application.