MIMAKI JV34-260 - Page 125

Printing on Double Side
4-13
1
1
4
Double Sided Printing
6
13
Adjust misalignment of scan direction on both sides.
• Press the keys and adjust the position.
14
Press the key.
15
Adjust the misalignment of the feed direction.
• Press the keys and adjust the position.
16
Press the key.
• Printing on the back side starts.
• When translucent media is selected, the Misalignment recheck line is printed before image data.
• If the scan direction is misaligned after checking the recheck line, press the key to stop
printing, and follow from the Step 1 again.
• Depending on media types, you cannot check the misalignment visually since the front line cannot be
seen from the back. In this case, slit up on the reference position with a cutter, measure the length to
the check line, and then input the difference with the jog key.
• Depending on media types, you cannot check the misalignment visually since the front line cannot be
seen from the back. In this case, slit up on the reference position with a cutter, measure the length to
the check line, and then input the difference with the jog key.
Bac kPr i n t POS . COMP .
Y:+ < 1.3mm > -
No misalignment
(No need to adjust)
Front
Adjust to minus direction.
If 1 mm misaligned, press
key to adjust -1mm.
Misalignment check line for scan direction
Back
Adjust to plus direction.
If 1 mm misaligned, press
key to adjust +1mm.
Bac kPr i n t POS . COMP .
X:+
⁄
1.3mm ⁄ -
No misalignment
(No need to adjust)
Front
Adjust to minus direction.
If 1 mm misaligned, press
key to adjust -1mm.
Misalignment check line
Back
Adjust to plus direction.
If 1 mm misaligned, press
key to adjust +1mm.