6-8
Message Cause Solution
The expiration date of an ink car-
tridge has passed (one month has
passed after the specified expiration
date).
The red LED blinks. Replace the car-
tridge generating the warning with a new
one.
The cartridge may be used until two
months pass after the specified expira-
tion date.
The expiration date of an ink car-
tridge has passed (two months
have passed after the specified
expiration date).
Replace the cartridge generating the
warning with a new one.
The ink has been extended the
expiry month and has been used.
Replace the ink cartridge. ( P.1-12)
For the ink extended the expiry
month, six months have passed
since the expiry month shown on
the cartridge.
Replace the ink cartridge. ( P.1-12)
Remaining amount of ink in an ink
cartridge is zero.
Replace the cartridge generating the
warning with a new one.
The waste ink tank is nearly full.
Replace the waste ink tank then execute
[MAINTENANCE]-[Ink Tank Exchange].
(P.5-29)
The cleaning liquid cartridge is
empty.
Replace the cleaning solution cartridge
with a new one.
The cleaning liquid cartridge has
not been installed.
Install the cleaning solution cartridge.
There is trouble with cleaning liquid
cartridge.
Check the cleaning solution cartridge.
The cover of the heavy-duty take-up
device opens.
Close the cover of the heavy-duty take-
up device.
If the error message is displayed even if
the cover is closed, contact our service
and sales office.
The control limit sensor of the
heavy-duty take-up device is
detected.
Move down the position of the tension
bar at the take up side. If the error mes-
sage is displayed even if you move it
down, contact our service and sales
office.
An abnormality occurs in the status
of take up of the heavy-duty take-up
device.
Conform whether the medium is taken
up with the heavy-duty take-up device
properly.
Confirm whether the paper core take up
the medium goes around in circles or
not.
To Next Page
Loading...
