MIMAKI JV34-260 - Tension Bar Adjustment for Media Feeding; Adjusting Tension Bars for Proper Feeding

2-14
11
Close the covers on the right and the left sides of the heavy-duty feeding device at
the back of this machine.
12
Lift the back tension-bar down to the
stopper slowly to tighten the media.
• Unlock the tension-bar, and then lift it down.
13
Push the clamp lever down.
14
Adjust the position of the tension-bar with the switches on the left of the heavy-duty
feeding device.
(1) Set the  switches to the take-up direction of the media.
(2) Turn the left switch to [MANUAL].
• The tension-bar is lifted, reeling the media. When the media is fed and the tension-bar is not
lifted, turn the
 switch to the other side.
(3) When the tension-bar arm becomes parallel to the floor, turn the left switch to AUTO to stop the
tension-bar.
(4) Turn the  switch to the feeding direction of the media.
Lock
Tension-bar
Clamp
lever
Adjust the arm to
become parallel to the
floor