MIMAKI JV34-260 - Final Media Securing and Selection Steps; Holding Media with Press and Selecting Roll Type

Setting a Media
2-15
1
2
Basic Operations
4
5
6
15
Hold the media lightly with the media press.
• Set the media not to get out of the right of the pinch roller on the right end.
• When using a thick media, remove the media press from the media before printing.
16
Close the front cover.
17
Press the key to select "ROLL" .
• Detects the media width.
• When [MEDIA RESIDUAL] of the maintenance function is "ON" ( P.5-25), the screen for entering
media remaining amount is displayed after detecting the media width. P.2-24)
• Do not set media at the position which the media press touches the side plate on the
right. As media may tilt and be lifted, it could break the head.
• If a media is misaligned to the right more than fixed
position, a warning is displayed. Set the media
again.
***** ERROR 50 *****
MED I A SE T POS I T I ON
Media press position : 8 to 18 mm from the side plate on the right.
(For the variation of the inside diameter of media roll, it ranges as above.)
Media
Media Press
Side plate of
the right
MED I A SE L E C T
ROL L < > L EA F