2-16
18
Secure the media on the take-up device. ( P.2-25)
(1) Feed the media up to the core of the roll media of the
take-up device by pressing the key.
(2) Secure the media as shown below.
19
Press the key to loosen the media.
• Loosen the media until it reaches to the floor.
20
Roll up the media around the paper core about once with the switch of the heavy-
duty take-up device.
(1) Turn the left switch to [MANUAL], and turn the right switch to the take-up direction of the
media to roll up the media.
(2) Just before the media is stretched, turn the left switch to [AUTO] to stop.
21
Press the jog key again to loose the media.
• Loosen the media until it reaches to the floor.
22
Lift the front tension-bar down slowly.
• Unlock the tension-bar, and then lift it down.
• Rolling up the media too tight, the right and the left covers of the take-up device may
open and an error [Cover Open] may be displayed.
In this case, open the right cover of the take-up device, and loosen the tension of the
media.
To Next Page
Loading...
