2-22
11
Make the roll media even then lower the clamp
lever.
• Pulling several positions of the media lightly, Lower the
clamp lever after confirming that the amount of the roll
media pulled out is almost even.
12
Hold the media with the media press gently.
• Set the media so that no media sticks out from the right end
pinch roller to the right side.
• When using a thick media, remove the media press from
the media before printing.
• Do not set media at the position which the media press touches the side plate on the
right. As media may tilt and be lifted, it could break the head.
• If a media is misaligned to the right more than fixed
position, a warning is displayed. Set the media
again.
Media press position : 8 to 18 mm from the side plate on the right.
(For the variation of the inside diameter of media roll, it ranges as above.)
Media
Media Press
Side plate of
the right
To Next Page
Loading...
