Setting a Media
2-23
1
2
Basic Operations
4
5
6
13
Prepare for the narrow take-up device.
(1) Set an empty core of the roll media on the take-up
device.
(2) Close the front cover.
14
Press the key to select "ROLL" .
• Detects the media width.
• When [MEDIA RESIDUAL] of the maintenance function is "ON"
( P.5-25), the screen for entering media remaining amount is displayed after detecting the media
width.( P.2-24)
15
Fix the media on the narrow take-up device.
(P.2-25)
(1) Feed the media up to the core of the roll media of the
take-up device by pressing the key.
• Check the media end is not caught into the slot on the
post-heater, and then feed the media.
(2) Fix the middle of the media with adhesive tape.
(3) In the same manner, fix the left side and right side of
the media.
• Make sure that the there is no slack or wrinkle on the
media in such condition that the roll media is pulled to
right and left evenly, and then stick the tape.
• Use the narrow take-up device to set the media with less than 1.6m wide.
• When setting a long paper core, the supporter of the roll holder may be stuck in the
center of the guide rail.
In this case, follow the procedures below.
(1) Loosen the fixing screw of the supporter, and push the arm down.
(2) Slide the roll holder.
(3) Raise the arm, and tighten the fixing screw of the supporter.
To Next Page
Loading...
