Mindray BeneVision TM80 - Adding the Number of the TM80 Telemetry Monitors

6-2 TM80 Telemetry Monitor Service Manual
Required materials
BP10 module. For the specific BOM, see NIBP-related bill of materials,
see9Maintenance Materials or consult Mindray engineers.
Upgrade method
Connect the BP10 module to the TM80 over MPAN as instructed in Chapter 10of
BeneVisionTMS60 Telemetry Monitoring System/TM80 Telemetry Monitor
Operator’s Manual.
Verification method
Start NIBP measurement on the BP10 module. Measurement results can be seen on
the TM80 and CMS.
6.3 Adding the Number of the TM80 Telemetry Monitors
The number of the TM80Telemetry Monitors can be added flexibly. If you need to
add one TM80 Telemetry Monitor, you only need to set CMS information in the TM80
menu and admit the TM80 on the CMS. The new TM80 monitor can work in the
system.
Required materials
TM80 monitor. For the specific BOM, see the chapter about maintenance material in
the manual or consult Mindray engineers.
Upgrade method
See the Operation Manual and connect the new TM80 monitor to the CMS.
Verification method
Connect the TM80 to a simulator or human body or enable demo mode on the
TM80. Relevant measurement results can be seen on the TM80 and CMS.