3-22 TM80 Telemetry Monitor Service Manual
3.3.2 Configuration Description
3.3.2.3 Login
On the command line interface (CLI), set the IP address of the WLC to 192.168.30.253
and subnet mask to 255.25.255.0 and enable login on the web page. Set the user
name for login to admin and the passcode to Cisco123. The user name and
passcode should be set in a unified way so as to facilitate maintenance and change
of the configuration later.
Set the IPv4 address of the PC to 192.168.30.1 and the subnet mask to 255.255.255.0
and connect the network port of the PC to port 1 of the WLC by using a network
cable.
Considering compatibility with the AC, Firefox browser is preferred. Internet Explorer
is secondly preferred. Enter https://192.168.0.253 in the address bar and choose to
trust the website. On the login page, click Login and enter the user name and
passcode to access the configuration page. Figure 1 shows the login page.
NOTE
Although the default settings of some WLCs are not changed, the
specific settings are displayed during setup due to the importance of
configuration. The operator just needs to confirm the settings without
the need to change them. If no specific description is provided during
setup, retain the default settings of WLC.
To Next Page
Loading...
