TM80 Telemetry Monitor Service Manual 3-23
After logging to the WLC, configure the WLC by performing the following steps:
1. Set the WLAN. This part includes SSID creation, General setting, Security setting,
QoS setting, and Advanced setting.
2. Set CONTROLLER. This part includes the General setting and Multicast setting.
3. Set WIRELESS. This part includes the setting of 802.11b/g/n and setting of APs.
3.3.3 WLAN Settings
3.3.3.1 Creating an SSID
1. Choose WLANs→New. The configuration page is displayed.
2. Perform the following configuration on the page, as shown below.
3. Click Apply and Save Configuration.
To Next Page
Loading...
