3-24 TM80 Telemetry Monitor Service Manual
3.3.3.2 General Settings
1. On the page, enable the WLAN, select a protocol supported by the WLAN,
select the VLAN where the WLAN is located, and enable broadcast SSID.
2. Choose WLANs→WLAN ID→General. The configuration page is displayed.
3. Perform the following configuration on the page.
Status=Enabled
Radio policy=All
Interface/Interface Group=VLAN ID
Broadcast SSID=Enabled
NOTE
Select the VLAN corresponding to the SSID for VLAN ID.
The figure below shows the specific General configuration.
4. Click Apply and Save Configuration.
To Next Page
Loading...
