TM80 Telemetry Monitor Service Manual 3-21
Quality of Service (QoS)
If the network is used by TM80 and other devices at the same time, it’s
recommended that the QoS level of the SSID and VLAN used by TM80 is set to
highest level to make sure that the data is real-time.
3.3 Configuration of Cisco Network Devices
This section describes how to configure Cisco WLC and APs to meet wireless
networking requirements of Mindray telemetry monitors. It consists of two parts: list
of supported network devices and specific configuration requirements.
Because the IT infrastructures of different hospitals are different, below
configuration is only for your reference. You need to modify the configuration
according to your hospital IT department.
3.3.1 Recommended Devices
WLC: Cisco 2500series
AP: Cisco 2802 0r 2602
To Next Page
Loading...
