TM80 Telemetry Monitor Service Manual 3-45
3.5.1 Preparation
3.5.1.1 Tools and Resources
WNDAP350 to be configured and power cable of WNDAP350
One network cable
One PC
Network
cable
WNDAP350
power cable
WNDAP350
power interface
WNDAP35 network
interface
Hardware to be prepared
3.5.1.2 Login
1. Set the IPv4 address of the PC to 192.168.0.1 and the subnet mask to
255.255.255.0 and connect the network port of the PC to the network
port of the WNDAP350 by using a network cable.
2. Open the IE, enter the default IP address of WNDAP35, namely
192.168.0.237, default user name admin, and passcode passcode, and
click LOGIN, as shown below.
To Next Page
Loading...
