Mindray BeneVision TM80 - Arrhythmia Monitoring

3-68 TM80 Telemetry Monitor Service Manual
3.9 Configuring WLAN Settings of TM80
This table lists the items that need to be configured to make proper operation of the
TM80.
Item Description Remarks
Main
Menu->Maintenance
-> Network->IP
Address Setup
Set static IP address or
DHCP
For details, please refer to
BeneVision TMS60 Telemetry
Monitoring System/TM80
Telemetry Monitor Operator’s
Manual
Main Menu ->
Maintenance->
Network-> WALN
Setup
Configure SSID,
passcode, EAP, etc.
For details, please refer to
BeneVision TM80 Telemetry
Monitor Operator’s
Manualand3.9
Configuring WLAN
Settings of TM80in this manual
Main Menu ->
Maintenance
->Network->
Connect CMS
Configure how to
connect to the CMS.
For details, please refer to
BeneVision TMS60 Telemetry
Monitoring System/TM80
Telemetry Monitor Operator’s
Manual
If CMS and TM80 are not in the
same subnet, multicast TTL should
be greater than 1.
It is recommended to set QoS to
High.
Main Menu ->
Maintenance->
Network-> Wireless
Setup
Select to use 2.4G band
or 5G band
5G band is highly recommended.
If 2.4G is selected, the TM80 can
only roam between 2.4G channels,
but never goes to 5G channels.
Vice verse.
For more details, refer to 3.9.5
5G
Band Channels.
Main Menu ->
Maintenance->
Network->EAPCertifi
cate
Manage CA certificates
and user certificates
For details, please refer to
BeneVision TM80 Telemetry
Monitor Operator’s Manual and
3.9.2EAP Setup in this manual.
Main
Menu->Maintenance
->Service-> WLAN
test->Roaming Test
Configure roam
parameters that will
affect TM80’s roaming
performance
For details, refer to 3.9.4.4
Roaming Test.