17 - 18 Operator’s Manual
17 Probes and Biopsy
For how to use a system, see the operator’s manual provided by the manufacturer.
When using a sterilant, follow the following steps:
a. Prepare a sterilant by using sterile distilled or softened water when necessary.
b. Immerse the probe head in the sterilant and shake the probe appropriately to remove any
bubbles on the probe surface.
For details about the probe immersion duration, see the operator’s manual provided by the
manufacturer.
c. Rinse the probe thoroughly by using a large amount of sterile distilled or softened water
(about 2 gallons) at room temperature for about 30 s to remove the residual disinfectant.
Repeat the operation twice. Or follow the sterilant manufacturer’s instructions regarding
rinsing.
d. Dry the probe by wiping with a piece of sterile disposable lint-free soft cloth.
Do not dry the probe by heating.
4. Check whether the probe has defects such as peeling, rifts, bumps, cracks, or liquid spill. If
such defects exist, the probe has reached the end of its service life. In this case, stop using it
and contact the Mindray service department.
5. Store the probe in a cool, clean and dry environment. And repeat the cleaning and sterilization
process before the next use.
Compatible Cleaners and Disinfectants
For the detailed information about cleaners and disinfectants, see Mindray Transducer Disinfectant
Recommendation.
For TEE probes, refer to accompanied manual for disinfection and sterilization.
17.1.6 Cleaning the probe cable and connector
Do not use cloth with water to clean the probe connector.
Perform the following procedure:
1. Wipe out the dust attached to surface of probe connector and cable.
2. Use soft brush to brush the dust inside probe connector gently.
3. Remained stain or dust attached to surface of cable or surface of connector should be washed
out by cloth with a little soapy water, and then air-dry.
1 Fluid level
To Next Page
Loading...
Need help?
General
