A Barcode Reader
Operator’s Manual A - 11
A.3 Parameter Defaults
Refer to the following table for parameter defaults of LS2208 and DS4308.
Parameter Defaults Parameter Defaults
1-D Symbologies Interleaved 2 of 5 (ITF)
UPC/EAN Interleaved 2 of 5 (ITF) Enable Enable
UPC-A Enable Set Lengths for I 2 of 5 14
UPC-E Enable I 2 of 5 Check Digit Verification Disable
UPC-E1 Disable Transmit I 2 of 5 Check Digit Disable
EAN-8/JAN 8 Enable Convert I 2 of 5 to EAN 13 Disable
EAN-13/JAN 13 Enable Codabar (NW - 7)
Bookland EAN Disable Codabar Enable
Decode UPC/EAN/JAN
Supplementals (2and 5 digits)
Ignore Set Lengths for Codabar 5 to 55
UPC/EAN/JAN
Supplemental Redundancy
10 CLSI Editing Disable
Transmit UPC-A Check Digit Enable NOTIS Editing Disable
Transmit UPC-E Check Digit Enable
Transmit UPC-E1 Check
Digit
Enable 2-D Symbologies
UPC-A Preamble System Character PDF417 Enable
UPC-E Preamble System Character MicroPDF417 Disable
UPC-E1 Preamble System Character Code 128 Emulation Disable
Convert UPC-E to A Disable Data Matrix Enable
Convert UPC-E1 to A Disable Maxicode Enable
EAN-8/JAN-8 Extend Disable QR Code Enable
UCC Coupon Extended Code Disable
Code 128
Code 128 Enable
UCC/EAN-128 Enable
ISBT 128 Enable
Code 39
Code 39 Enable
Trioptic Code 39 Disable
Convert Code 39 to Code 32
(Italian Pharmacy Code)
Disable
Code 32 Prefix Disable
Set Length(s) for Code 39 2 to 55
To Next Page
Loading...
Need help?
General
