FrameMaker Ver.5.5E(PC) Di251/Di351 DIS/REASSEMBLY, ADJUSTMENT
05.03.01
D-21
4. Slide the pulley to the front and fit one retaining
ring E type.
5. Pushing the pulley tightly up against the retaining
ring E type, secure the pulley with one screw.
4011D048AA
6. Wind the fixed bead end of the cable around pul-
ley D and pulley C and fit the fixed bead at a posi-
tion about 5.5 mm from the Scanner rail.
4011D049AC
pulley C
pulley D
7. Wind the hook end of the cable around pulley A
and pulley B.
4011D102AA
pulley A
pulley B
8. Install the cable guide, fit the hook end of the
cable into the groove in the cable guide, and hook
the spring.
4011D050AA
Cable Guide
9. Position the round bead of the cable (black) at the
position shown in the illustration.
Rear
1167D051AC
To Next Page
Loading...
