FrameMaker Ver.5.5E(PC) Di251/Di351 DIS/REASSEMBLY, ADJUSTMENT
05.03.01
D-37
(3) Loop Adjustment
Requirement
Adjust so that a correct loop is formed before the Synchronizing Rollers when paper is fed
through
NOTE
• This adjustment is to be made when any of the following symptoms occurs: variations in
the amount of print leading edge void, paper skew, and misfeed.
Adjustment Procedure
1. Call the Tech. Rep. Mode to the screen.
2. Touch "Tech. Rep. Choice" and "Printer", in that order.
3. Touch "Loop Adjustment" to call up the Loop Adjustment function.
4. Select the paper source, for which the adjustment is to be made.
5. Press the Clear key to clear the current setting value.
6. Enter the new setting value from the 10-Key Pad.
✽ Use the Access Mode key or "✽" to change the + or - sign.
Setting Instructions
• Change the setting value as necessary until there are no variations in the amount of void
image along the leading edge, skewed feeding, dog-ear, or misfeed.
7. Touch "END" to validate the setting value.
NOTE
• Be sure to touch the "END" key before returning to normal operation mode. If the Panel
Reset Key is used, the previous setting remains valid.
8. Perform the same steps to adjust for other paper sources.
Adjust Mode Setting Value
Loop Adjustment -5 to +5
Setting Value
4011P298CA
4011D001AA
Use to change
the + or- sign.
Usetoclear
setting value.
Use to enter setting value.
Use to change the + or- sign.
To Next Page
Loading...
