(2) Original Size Detecting Sensor Adjustment (F7-1)
Make this adjustment after any of the following procedures have been performed:
• Memory Clear
• A faulty original size detection occurs
• Replacement of the CCD Unit and Scanner parts (including the Exposure Lamp)
• Original Size Detecting Sensor addition or replacement
• ROM/RAM Board replacement
Adjustment Procedure
2. Call the Tech. Rep. Mode to the screen.
3. Touch "Function" to display the Function menu.
4. Touch "F7-1".
5. Press the Start key to run the Original Size Detecting Sensor Adjustment function.
6. Turn OFF and ON the Power Switch.
NOTE
• The Start key remains lit up orange while this function is being run and lights up green as
soon as the sequence is completed.
1. Stack five sheets of blank A3 or 11×17 paper on
the Original Glass and lower the Original Cover.
1167D110AB
To Next Page
Loading...
