FrameMaker Ver.5.5E(PC) Di251/Di351 DIS/REASSEMBLY, ADJUSTMENT
05.03.01
D-35
3-5. ELECTRICAL/IMAGE ADJUSTMENT
(1) Touch Panel Adj.
Make this adjustment after either of the following procedures have been performed:
• Memory Clear
• Control Panel replacement
• ROM/RAM Board replacement
Adjustment Procedure
1. Call the Initial mode to the screen. (For details, see SWITCHES ON PWBs, TECH.
REP. SETTINGS.)
2. Touch "Touch Panel Adj. ".
3. Touch "+" on screen 1 shown above.
NOTES
• At this time, make sure that the very center of "+" is touched with the tip of a ballpoint
pen or similar device.
• Use care not to damage the screen with the tip of a ballpoint pen.
4. Touch "+" on screen 2 shown above.
5. Touch "+" on screen 3 shown above.
6. Touch "+" on screen 4 shown above.
“Initial” Screen
4011P304CA
4011P305CA4011P306CA
4
12
3
4011P303CA
To Next Page
Loading...
