<Right/Left>
Requirement
NOTE
• This adjustment must be made when the PH Unit has been replaced and after Registra-
tion (CD) (Printer) have been made.
Adjustment Procedure
1. Call the Tech. Rep. Mode to the screen.
2. Touch "Tech. Rep. Choice" and "Printer", in that order.
3. Touch "Edge Erase" and "Right/Left" in that order to call up the Right/Left Edge Erase
adjustment function.
4. Press the Clear key to clear the current setting value.
5. Enter the new setting value from the 10-Key Pad.
Setting Instructions
To make the edge erase width (width A) smaller, decrease the setting value.
To make the edge erase width (width A) greater, increase the setting value.
6. Touch "END" to validate the setting value.
NOTE
• Be sure to touch "END" to return to the normal operating mode. If the Panel Reset key is
used, the previous setting remains valid.
A
A
1171D005AA
Set the erase width on the right and left edges of
paper (width A) in the range between 0 and 5 mm.
Adjust Mode Setting Range
Edge Erase/Right/Left 0 to 5
1171D005AA
4011D299CA
1167D069AA
Usetoclear
setting value.
Use to enter setting value.
Setting Value
To Next Page
Loading...
