Mirion Technologies AVIOR-2 - Power on

USE MANUAL
AVIOR-2/AVIOR-2 I/O & MIP-2/MIP-2 I/O
22 / 118
106491_C User manual AVIOR-2 MIP-2_En.docx
MIRION TECHNOLOGIES (Canberra) S.A.S, BP249, ZI de Vauzelles, 3760
2
Loches Cedex
11.2 POWER ON
The power is turned on by pressing the keyboard button .
During the start-up phase, the system initializes, a sound signal is generated, the software version is
displayed at the bottom of the screen, the interface 1 and interface 2 LEDs light up according to the red,
green and blue colour cycle then go off and the relays follow a cycle of activation and deactivation.
The AVIOR-2 and the MIP-2 offer 4 measurement modes:

Direct measurement (default mode at start-up),

Counting scale,

Screening,

Hand / Foot
Note: At start-up the last measurement mode used before shutdown is automatically started.
AVIOR-2 and MIP-2 have 3 user levels:
x Administrator, user and system manager, with an increased knowledge of metrology.
x Technician, person who uses the system and has a metrological culture.
x Operator, person who uses the system and has no particular knowledge of metrology.
Note: The last user connected before shutdown is used at start-up and is asked to enter the
associated password. In case of failure the « Operator » profile is loaded.
The measurement modes are accessible according to the user level:
User
Direct
measurement
(§ 10.3)
Counting
scale (§
10.4)
Screening
(§ 10.5)
Hand/foot
(§ 10.6)
Temporary
inhibition
of audible
alarm
Administrator
9 9 9 9 9
Technician
9 9 9 9 9
Operator
9 9
-
9
Access to the functions of AVIOR-2 or MIP-2 according to the user level are given in the table:
Functions Administrator Technician Operator
Measure type (NET/RAW) (§ 10.7)
9 9 9
Lock function (§ 10.8)
9 9
-
Power off AVIOR-2 or MIP-2 (§ 10.9)
9 9 9
Unit & Alarms (§ 12.1)
9 9
Unit
Probe IPC (§ 12.3)
9
Validity Date Validity Date
Validity check of probe CPC (§ 12.4)
9 9 9