Mirion Technologies AVIOR-2 - Direct Measurement Mode

USER MANUAL
AVIOR-2/AVIOR-2 I/O & MIP-2/MIP-2 I/O
106491_C User manual AVIOR-2 MIP-2_En.docx
MIRION TECHNOLOGIES (Canberra)S.A.S, BP249, ZI de Vauzelles, 37602
Loches Cedex
27 / 118
11.3 DIRECT MEASUREMENT MODE
The « Direct Measurement » mode is used to perform a body measurement or object contamination.
Direct measurement determines fixed surface contamination plus no fixed surface contamination, but
may be disturbed by radiation from the inside of the object being checked or the environment.
Direct measurement is accessible by all user levels.
The unit of measurement displayed is the measuring unit of the probe.
The unit of measure can be set according to the user level and the type of probe.
User
Bq/cm
2
Bq
c/s
Sv/h (*)
Administrator
9 9 9 9
Technician
9 9 9 9
Operator
9 9
(*) : According to probe type
Where the AVIOR-2/MIP-2 is in another mode, press the key or to access the main 1.
menu.
Note: The line « Measure mode » is selected by default. If necessary press the keys or
to select the line.