Mitel 6920 - Paging Key; Configuring a Paging Key Using the Mitel Web UI

103
C
ONFIGURING SOFTKEYS PAGING KEY
Softkeys
2. Select from Key 1 through Key 20 on the Top keys.
or
Select from Key 1 through Key 18 on the Bottom keys.
3. In the Type field, select Phone Lock from the list of options.
Expansion Module Keys
4. Select from Key 1 through Key 84(M695).
5. In the Type field, select Phone Lock from the list of options.
6. Click Save Settings.
NOTE: You can lock/unlock the phone using the new key you just configured, using the Mitel Web UI
at the path Operation > Phone Lock, or using the Phone Lock option on the IP phone UI at the path
Options > Lock > Phone Lock.
Paging Key
You can configure a Paging key on the phone that allows you to send a Real Time Transport Protocol
(RTP) stream to pre-configured multicast address(es) without involving SIP signaling. You enter a multi-
cast IP address(es) and a port number for the Paging key, that when pressed, initiates an outgoing multi-
cast RTP session. This is called Group Paging on the IP phones.
You can also specify group paging RTP addresses that the phone listens for when receiving RTP
streams. You can specify up to 5 listening multicast addresses at the path, Basic Settings > Preferences
> Group Paging RTP Settings.
Configuring a Paging Key Using the Mitel Web UI
1. Click on Operation > Softkeys and XML.
or
Click on Operation > Expansion Module <N>.