84
C
ONFIGURING SOFTKEYS FLASH KEY
4. To exit from the XML screen, press the XML softkey again or press the button.
Flash Key
You can set a key to generate a flash event when it is pressed on the 6920. You do this by setting the
key to Flash. The IP phone generates flash events only when a call is connected and there is an active
RTP stream (for example, when the call is not on hold).
Configuring a Flash Key Using the Mitel Web UI
1. Click on Operation > Softkeys and XML.
or
Click on Operation > Expansion Module <N>.
Softkeys
2. Select from Key 1 through Key 20 on the Top keys.
or
Select from Key 1 through Key 18 on the Bottom keys.
3. In the Type field, select Flash.
4. In the Label field, enter a label to display on the phone for the key.
Expansion Module Keys
5. Select from Key 1 through Key 84(M695).
6. In the Type field, select Flash.
7. Click Save Settings.
Sprecode Key
You can set a key to automatically activate specific services offered by the server by setting a key to Spre-
code. For example, if the sprecode value of *82 is configured, then by pressing the key, *82 automatically
activates a service provided by the server. The value you enter for this field is dependent on the services
provided by the server. Contact your System Administrator for information about available services.
To Next Page
Loading...
