Mitel 6920 - Page 190

180
A
DDITIONAL FEATURES PREFERRED LINE AND PREFERRED LINE TIMEOUT
The following table provides the behavior of the preferred line focus feature with other features on the
phone:
NOTE:
1. you specify a value of 0 for the Preferred Line parameter, it disables the preferred line focus feature.
2. If you specify a value of 0 for the Preferred Line Timeout parameter, the phone returns the line to
the preferred line immediately.
Phone Feature Preferred Line Behavior
Last Call Return The phone switches back to the focused line
immediately after the call ends.
Speeddial The line is already specified when the speed dial
is created. The phone switches back immediately
after the call ends.
Conference For incoming calls, the phone switches back
immediately after the call ends.
Transfer For incoming or outgoing calls, the current
behavior is that the same line used to transfer the
call does not change. For incoming calls, the
phone switches back immediately after the call
transfers.
Park The phone switches back immediately after the
call ends.
Voicemail The phone switches back immediately after the
call ends.
Outgoing Redial The phone switches back immediately after the
call ends.
Dialing For incomplete dialing on a non-preferred line,
the focus does not change if some digits are
entered. If no digits are entered or digits were
cleared, the focus changes to preferred line after
the time out has passed without activities.
Caller ID If the Switch UI Focus To Ringing Line parameter
is disabled, the User is able to see the Caller ID
when the phone switches the focus to the ringing
line.
Factory Default Factory default and recovery mode clears the
preferred line and preferred line timeout
parameters, and the phone operates in a
non-preferred line mode.