Mitel MiVoice Business SMB Controller User Manual

About SMB Controller
Note:
To install or remove Interface or DSP cards, power down the system, and unplug the
power cord. Follow the proper Electrostatic Discharge (ESD) precautions. Ensure
the chassis is grounded, see Earthing (Grounding) the SMB Controller. Wait three
minutes before touching the hardware. For more details see, Installing the Interface
and DSP Cards.
Some SMB Controller hardware information are as follows:
•
The SMB Controller has an Equipment ID (EID) that is hard coded on the Processor Board.
•
Four optional expansion interface cards can be installed.
•
The number of supported Users, Voice over Internet Protocol (VoIP) Channels, and Voice
Mail / Auto Attendant Ports depends on the number of DSP Cards in the system.
2.4.3.1 Summary of Parts for MiVoice Business on
SMB Controller
Part Number Name Comments
50008381 SMB Controller
8/38G
SMB platform
20351208 System module 2
DSPX
See section System Configurations on
page 36 for information about system
configurations by number of DSP cards
required
20350436 Expansion interface
card 4 x a/b
4 FXS ports
50008254 SMB Controller Trunk
card 2FXO
2 Port FXO
50008255 SMB Controller Trunk
card 4FXO
4 Port FXO
Document Version 1.0
35 System Manual for Mitel SMB Controller

Mitel MiVoice Business SMB Controller Specifications

General

Brand	Mitel
Model	MiVoice Business SMB Controller
Category	Controller
Language	English