Mitsubishi Electric QJ71GF11-T2 - Starting the Interrupt Program of the Master Station (Station Number 0) When the Master Station Receives Data Sent from Another Station Using the SEND

112
(b) Starting the interrupt program of the master station (station number 0) when the
master station receives data sent from another station using the SEND instruction
The following is a setting example to execute the interrupt program corresponding to the interrupt pointer I52
when the master station (station number 0) receives data sent from the local station (station number 1) using
the SEND instruction in channel 2.
1. Set the interrupt setting parameters for the master/local module (station number 0) in the
"Interrupt Settings" window as shown below.
2. Set the parameters in the "Intelligent Function Module Interrupt Pointer Setting" window as shown
below.
1
2
3
I52
SM400
IRET
RECVS
Interrupt program
execution
Channel 2
Channel 1
Channel 2
SEND
Master station
(Station No.0)
Local station
(Station No.1)
Master/local module Master/local module
CPU module CPU module
Channel 1
1 2
3
Set the same SI number as the interrupt settings.