Mitsubishi Electric QJ71GF11-T2 - Setting Data

248
(1) Setting data
Setting data Description Set by Data type
Jn
Own station's network No. (1 to 239, 254)
254: Network specified in Valid Module During Other Station
Access
User
16-bit binary
Un
Start I/O number of the master/local module of the own station
(00 to FE
H
: Upper two digits of the I/O number expressed in
three digits)
(S1)
Start device of the own station where control data is stored
( Page 249, Section 10.4 (1) (a))
Device name
(S2)
Start device of the target station where data to be read is stored
( Page 251, Section 10.4 (1) (b))
(D1)
Start device of the own station where read data is stored
A continuous area for the read data length is required
( Page 251, Section 10.4 (1) (c))
System
(D2)
The device of the own station that turns on for one scan upon
completion of the instruction.
If the instruction fails, (D2)+1 also turns on.
Bit