Mitsubishi Electric QJ71GF11-T2 - Other Functions

39
CHAPTER 3 SPECIFICATIONS
3
3.3 Function List
(5) Other functions
:Available, ×: Not available
Function Description
Availability
Reference
Master
station,
submaster
station
Local
station
Reserved station specification
The reserved stations are included in the
number of stations that will be connected to the
network in the future without actually connecting
them. Reserved stations are not detected as
faulty stations even though they are not actually
connected.
×
Page 175, Section 8.4
Page 225, Section 9.6
Temporary cancel of the reserved
station setting
Reserved station specification can be
temporarily cancelled without changing the
parameters.
×
Error invalid station and temporary
error invalid station setting
Prevent the master station from detecting a
slave station as a faulty station even if the slave
station is disconnected during data link. This can
be used when replacing a slave station during
data link, for instance.
×
Page 176, Section 8.5
Page 229, Section 9.7
Interrupt request to a CPU module
Interrupt conditions are checked every link scan,
and if the interrupt conditions are met, an
interrupt request is made to the CPU module to
start the interrupt program.
Page 107, Section 7.6
Page 177, Section 8.6
IP packet transfer function
Communications in a protocol, such as FTP and
HTTP, using the specified IP address of an
Ethernet device can be performed over CC-Link
IE Field Network.
With this function, two networks of CC-Link IE
Field Network and Ethernet are not required,
resulting in reduced wiring cost.
Page 146, Section 8.3
Station number setting using a
program
The station numbers of a local station (own
station) can be set using a program.
When there are local stations with the same
program and network parameters (excluding the
station numbers), setting the station numbers
using a program allows project data items other
than the station number to be the same, leading
to reduced development work hours.
×
Page 380, Section
10.18
Data backup/restoration
The setting data of the slave station is backed
up into the SD memory card of the CPU module
on the master station.
The setting data backed up on the SD memory
card of the CPU module on the master station is
restored into the slave module.
(Master
station only)
iQ Sensor
Solution Reference
Manual