88
7.3 Network Configuration Settings
Set parameters of slave stations (the number of points and assignment of link devices) in the master station and
submaster station. Set a link scan mode and block data assurance per station as well.
Two methods are available to configure the network configuration settings as listed in the following table.
These parameters can be set only for the master station and submaster station. (To set these parameters for the
submaster station, set a value other than "0" in "Total Stations".)
Item Description
Setting on the graphical window (CC IE Field
configuration window)
The network configuration can be set while checking the CC-Link IE Field
Network configuration graphically.
Slave stations are added by selecting the model name displayed on the
window; therefore, a setting error in the station type can be prevented.
Unlike the setting on the window in the table format, the following can be
performed.
• Change transmission path method ( Page 91, Section 7.3 (1) (b))
• Parameter processing of a slave station ( Page 95, Section 7.3 (1) (e))
• Command execution of a slave station ( Page 96, Section 7.3 (1) (f))
Setting on the window in the table format
The CC-Link IE Field Network configuration is configured manually. (The
station type is also set manually.)
Unlike the setting on the graphical window (CC IE Field configuration window),
the network configuration is not displayed graphically.
( Page 97, Section 7.3 (2))
To Next Page
Loading...
