Mitsubishi Electric QJ71GF11-T2 - CCPASET Instruction Execution Timing

370
(d) CCPASET instruction execution timing
• When completed
• When failed
(3) Checking error details
If the dedicated instruction fails, error details can be checked by either of the following methods:
(a) In GX Works2
Error details can be checked using the CC-Link IE Field Network diagnostics. ( Page 206, CHAPTER 9)
(b) Using devices
Completion status indication device ((D)+1) turns on, and an error code is stored in Completion status ((S1)+0)
of the control data.
According to the error code, check the error details and take a corrective action.
( Page 439, Section 12.5)
1 scan
CCPASET
Sequence scan
Start contact
Own station CPU
Master/local module
OFF
Completion device
(Device specified in (D))
Completion status indication
device (Device of (D)+1)
END0 END0
Parameter setting
END0 END0 END0
1 scan
CCPASET
Sequence scan
Start contact
Own station CPU
Master/local module
Completion device
(Device specified in (D))
Completion status indication
device (Device of (D)+1)
Error code
Completion status
(Device of (S1)+0)
END0 END0
Parameter setting error
END0 END0 END0