119
CHAPTER 7 PARAMETER SETTING
7
7.8 Routing Parameters
7.8 Routing Parameters
Set communication paths for transient transmission between a station in the own network and stations in other
networks.
The parameters need to be set in the following cases.
• To perform transient transmission with stations on different networks using dedicated instructions
( Page 236, CHAPTER 10)
• To use the IP packet transfer function ( Page 146, Section 8.3)
(1) Setting procedure
1. Open the setting window.
Project window [Parameter] [Network Parameter] [Ethernet/CC IE/MELSECNET]
button
2. Set parameters in the window.
3. Click the button.
To Next Page
Loading...
