Mitsubishi Electric QJ71GF11-T2 - Parameters Set for Slave Stations

83
CHAPTER 7 PARAMETER SETTING
7
7.1 Parameter List
*1 The parameter settings must be the same as those for the master station.
*2 This can be set when the checkbox next to "Set the network configuration setting in the CC IE Field configuration
window" is selected.
● When parameters are not set
The master/local module operates as the master station in network number 1. In this case, only transient transmission is
performed. (Cyclic transmission is not performed.)
(2) Parameters set for slave stations
For the parameters of a slave station, refer to the manual for the slave station used.
Network
Operation
Settings
Parameter Name
Page 101,
Section 7.4
Data Link Faulty Station Setting
Output Setting During CPU STOP
Set IP address 
*1
Refresh Parameters
Page 103,
Section 7.5
Interrupt Settings
Page 107,
Section 7.6
Station number setting method

Page 84, Section
7.2
Select the parameter to be used.

*2
Page 84, Section
7.2
Interlink Transmission Parameters

Page 113,
Section 7.7
Routing Parameters
Page 119,
Section 7.8
Item
Necessity of setting
Reference
Master
station
Local
station
Submaster
station
3
4
5
6
7
8
9