Mitsubishi Electric QJ71GF11-T2 - Network Configuration Setting Data (Master Station (Needs to be Set) and Submaster Station Only)

367
CHAPTER 10 DEDICATED INSTRUCTIONS
10
10.17 GP.CCPASET (Setting Parameters) 10.17.2 Instruction details
(b) Network configuration setting data (master station (needs to be set) and submaster
station only)
When the existence (b0) of the network configuration setting data is enabled by the setting flag ((S1)+1),
configure the network configuration settings.
Use (S1)+2 to specify the number of stations set by the total number of slave stations.
Device Item Setting data Setting range Set by
(S2)+0
For the 1st station
Slave station
setting
information
Store the station type and station number.
Refer to the left figure.
User
(S2)+1
RX/RY
offset
Store the RX/RY start number. (In increments of 16 points)
0 to 3FF0
H
(S2)+2
RX/RY
size
Store the number of RX/RY points. (In increments of 16 points) 0 to 2048
(S2)+3
RWw/RWr
offset
Store the RWw/RWr start number. (In increments of 4 points)
0 to 1FFC
H
(S2)+4
RWw/RWr
size
Store the number of RWw/RWr points. (In increments of 4 points) 0 to 1024
(S2)+5 to
(S2)+599
•
•
•
•
•
(S2)+600
For the 121st station
Slave station
setting
information
Same as (S2)+0 to (S2)+4
(S2)+601
RX/RY
offset
(S2)+602
RX/RY
size
(S2)+603
RWr/RWw
offset
(S2)+604
RWr/RWw
size
0: Remote I/O station
1: Remote device station
2: Intelligent device station
3: Local station
4: Sub master station
F: Master station
Station No.
to b0b15 to b12 b11 to b8 b7
Station type Fixed to 1
H
0: Master station
(only when the submaster
function is used)
1 to 120: Station No.