Mitsubishi Electric QJ71GF11-T2 - To Check Whether Routing Parameters Have Been Correctly Set; Different Control Cpus Are Set to the Network Modules on a Relay Station in a Multiple CPU System; When Multiple Master;Local Modules with the same Network Number Are Connected to One System

121
CHAPTER 7 PARAMETER SETTING
7
7.8 Routing Parameters
(2) Checking method
To check whether routing parameters have been correctly set and transient transmission can be performed,
perform a communication test from CC-Link IE Field Network diagnostics. ( Page 79, Section 6.4.3)
(3) Precautions
(a) Different control CPUs are set to the network modules on a relay station in a
multiple CPU system
Set the same routing parameters to all the control CPUs.
(b) When multiple master/local modules with the same network number are connected
to one system
Set the station number of a module with the smallest slot number in "Relay Station No.".
In a multiple CPU system, set the station number of a module with the smallest slot number, regardless of the
CPU number of the control CPU.
1
2
1
2
1
2
Control CPU setting
Set the same routing parameters.
Station
No.0
Slot No. 0 1 2
Station
No.1
Station
No.2
Station
No.3
CPU
module
Station
No.0
Network No.1
Set "1" in "Relay Station No.".
Network No.2