Mitsubishi Electric QJ71GF11-T2 - How to Configure the Settings on the Graphical Window (CC IE Field Configuration Window)

89
CHAPTER 7 PARAMETER SETTING
7
7.3 Network Configuration Settings
(1) How to configure the settings on the graphical window (CC IE Field
configuration window)
1. Select the checkbox next to "Set the network configuration setting in the CC IE Field configuration
window". ( Page 84, Section 7.2)
2. Configure the network setting. ( Page 84, Section 7.2)
3. Open the setting window.
Project window [Parameter] [Network Parameter] [Ethernet/CC IE/MELSECNET]
button
4. Select the module under "Module List" and drag and drop it to the station list area or the device
map area.
The slave station is added to the station list area. The added module is displayed in the device map area.
5. Configure the setting of each item described after (a).
6. After the setting is completed, close the window.
[CC IE Field Configuration] [Close with Reflecting the Setting]
Remark
For how to operate the setting window, refer to the following.
GX Works2 Version1 Operating Manual (Common)
Drag and drop the text.
List of stations
Configuration
of the
devices