Mitsubishi Electric QJ71GF11-T2 - Network Components; Cables

59
CHAPTER 5 SYSTEM CONFIGURATION
5
5.3 Network Components 5.3.1 Cables
5.3 Network Components
CC-Link IE Field Network consists of components such as cables and hubs.
5.3.1 Cables
For wiring, use the 1000BASE-T compliant Ethernet cables.
● For CC-Link IE Field Network wiring, use the recommended wiring components by CC-Link Partner Association.
● Cables for CC-Link IE Controller Network cannot be used for CC-Link IE Field Network.
(1) Product
Cables for CC-Link IE Field Network are available from Mitsubishi Electric System & Service Co., Ltd. (Catalogs
for cable are also available.)
Also, the connector processing of cable length is available for your preference. Please consult your local
Mitsubishi Electric System & Service Co., Ltd.
Remark
● Cable types
The following cable types are available depending on the operating environment:
• Standard type: Cables for inside the control panel and indoor connection
• L type: Cables for outdoor connection
Cables and relay adapters of flame retardant or waterproof type are also available. Please contact your Mitsubishi
Electric System & Service Co., Ltd.
Ethernet cable Connector Type
Category 5e or higher
(Double shielded/STP) Straight cable
RJ45 connector
The following conditioning cables:
• IEEE802.3 (10000BASE-T)
• ANSI/TIA/EIA-568-B (Category 5e)
Type Model (manufacturer)
CC-Link IE Field Network cable SC-E5EW series (Mitsubishi Electric System & Service Co., Ltd.)