Mitsubishi Electric QJ71GF11-T2 - Page 535

533
APPENDICES
A
Appendix 7 Mounting the Master/Local Module with a C Controller Module Appendix 7.1 Setting the parameters using the buffer memory in the master/local module
(3) Intelligent function module switch setting
Configure the I/O assignment setting and intelligent function module switch setting in "C Controller setting utility"
or "Setting/monitoring tools for the C Controller module" and write the parameters to the C Controller module.
Remark
To configure the settings of a C Controller module, "C Controller setting utility" and "Setting/monitoring tools for the C
Controller module" are available. The software that can be used varies depending on the C Controller module used.
( Manual for the C Controller module used)
1. Set the master/local module in the "I/O assignment settings" tab.
• With the C Controller setting utility
C Controller setting utility "I/O assignment settings" tab
• With the setting/monitoring tools for the C Controller module
Setting/monitoring tools for the C Controller module [Parameter] [CCPU Parameter] "I/O
assignment settings" tab