Chapter 5: Process Interfaces
69
Failsafe Timeout
The timeout value is defined in milliseconds.
If the value is > 0 the timeout function is active.
If the time for the next command is bigger then the timeout time a Timeout Error occurred.
If a Timeout Error occurred, the operation LED switch to red and the valve is shutdown.
To activate the valve controller you have to set the Valve Override to Normal status and send a
setpoint.
To clear the red timeout LED you have to read the Communication Status.
At delivery the timeout function is deactivated by a value of 0.
A new timeout value is stored in the non-volatile memory of the device.
To Next Page
