8 Settings via the MICT
116 Rev. 03/2019
– Operating Hours
– Spark Plugs
Indicates the current operating hours of the spark plugs
– Engine
Indication of current operating hours of the engine
– Device State
The status of the device is shown by the following status displays:
Device status Description
Idle The ignition is ready and waiting for pickup activity.
Synchronizing Pickup signals are being received and analyzed.
Firing Active The ignition is active.
Firing Locked Pickup signals are being received and are valid, ignition is
not released.
Wait for Stop Pickup signals are being received, the ignition fired above
the security speed, and the ignition release was retracted.
The engine must now come to a standstill.
Configuration The device is being configured.
Self Test The self test is running (refer to Self Test on page 77).
Start Phase The engine is in the configured start phase (refer to section
Timing – Schedule A/B – Energy on page 104).
Warning A warning has occurred (refer to Warnings on page 133).
Error An error has occurred (refer to Failure on page 134).
Alarm A configured alarm has occurred (refer to Alarms on
page 134).
– Control
– Firing Enabled
The green status display signals that the firing is active.
– Schedule A/B
The green status display shows which parameter settings are currently used.
– GPI1
The status display shows the status of the input signal.
– Output
– GPO1
The general purpose output is switched on with the green status display.
To Next Page
Loading...
