Motortech MIC5 User Manual

8 Settings via the MICT
Rev. 03/2019 135
Error Description
Cycle signal was missing, so more
trigger signals were counted than
available per cycle.
Cycle signal was missing, so more trigger signals were
counted than available per cycle. Check the pickups and
the corresponding configuration (see Engine – Pickups on
page 96). Furthermore, also pay attention to the
instructions in the section entitled Pickup Input Errors on
page 164.
Device started after supply voltage
failure.
The device was started after a failure of the supply
voltage. Please check the power supply of the device
where applicable.
General error number. General error number. An undefined error has occurred.
Restart the ignition controller. If the error occurs again
after restarting the device, please contact MOTORTECH.
General error in pickup
pre-processing on pickup input
PUnumber.
General error in pickup pre-processing on pickup input
PUnumber. Check the pickups and the corresponding
configuration (see Engine – Pickups on page 96).
Furthermore, also pay attention to the instructions in the
section entitled Pickup Input Errors on page 164.
Number of trigger signals
(number) counted does not match
the configured value.
Number of trigger signals (number) counted does not
match the configured value. Check the pickups and the
corresponding configuration (see Engine – Pickups on
page 96). Furthermore, also pay attention to the
instructions in the section entitled Pickup Input Errors on
page 164.
Operational error caused by
pickup signals. PU1 = x, PU2 = y,
PU3 = z.
Operational error caused by pickup signals. Pickup
PU1 = x, Pickup PU2 = y, Pickup PU3 = z.
For information on the numbers shown, please consult
the documentation on the pickup status bits on the
storage device enclosed with the ignition controller. You
can open the file via the menu: Documentation -> More
information.
Check the pickups and the corresponding configuration
(see Engine – Pickups on page 96). Furthermore, also pay
attention to the instructions in the section entitled Pickup
Input Errors on page 164.
Output board identification failed
due to a checksum error.
The identification of the output board failed due to a
checksum error. Restart the ignition controller. If the error
occurs again after restarting the device, please contact
MOTORTECH.

Motortech MIC5 Specifications

General

Brand	Motortech
Model	MIC5
Category	Controller
Language	English