4 Product Description
24 Rev. 03/2019
Inputs and outputs Values
Binary input (GPI, general
purpose input)
Wiring
Input current: max. 20 mA
Low level: 0 V to 0.8 V
High level: 2.8 V to 32 V
(Function dependent on the configuration in MICT, see
Inputs/Outputs – Inputs on page 110)
Go/NoGo and GPO outputs One GPO (General Purpose Output) and one Go/NoGo output
Implementation as optical MOSFET relay
Maximum switching voltage: 32 V DC
Peak/steady current: max. 100 mA DC
Output power: max. 2.5 W
Internal resistance: 58 Ω to 60 Ω
Activation delay: 0.5 ms / max. 100 mA load
Deactivation delay: 0.2 ms / max. 100 mA load
If a short is found at the output, a safety circuit, which makes
the output highly resistive, is found at the output, so that the
current sets itself at 50 mA to 60 mA.
Signal LED Six LEDs are used as status indicators.
ASO output TTL level (5 V)
max. current: ± 10 mA
Pickup input Impedance: 10 k
The voltage supply for active pickup can be set using the
MICT from 5 V to 24 V.
Max. frequency for the pickups: 10 kHz
The formula for determining the frequency of the pickups can
be found in the note following this table.
For a pickup output impedance of 120 to 10 k, the pickups
connected to the MIC5 may not have a higher voltage than
±40 V and the connected power may not exceed 1 W.
Ignition coil outputs Output voltage: max. 250 V
Output energy in normal operation: max. 500 mJ (depending
on the ignition coils used)
Output energy in the start-up phase: max. 630 mJ (MIC5),
max. 600 mJ (MIC5-SE)
To Next Page
Loading...
