MR tapcon 240 - Displaying information about device; Displaying the info screen; Displaying measured values

7 Functions and settings
Maschinenfabrik Reinhausen 2014138 222/08 ENTAPCON® 240
1. > Configuration > Continue > Continue > Con-
tinue > Comm. interface 2 > Press until the desired parameter
is displayed.
ð Transmission delay CIC 2.
2. Press to increase the value or to reduce it.
3. Press .
ð The transmission delay time for the RS485 interface is set.
Displaying information about device
The next section describes how you can display information about the de-
vice.
Displaying the info screen
Information about the device can be viewed here.
The following information is displayed:
▪ Device model
▪ Firmware version number
▪ Serial number
▪ RAM
▪ Additional cards
To display the info screen, proceed as follows:
► > Info
ð Info.
Displaying measured values
The current measured values are shown in this display. The following meas-
ured values can be displayed:
To display the measured values, proceed as follows:
7.16
7.16.1
7.16.2