EasyManua.ls Logo

MR tapcon 240 - Transportation, receipt and handling of shipments; Storage of shipments

MR tapcon 240
174 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4 Packaging, transport and storage
Maschinenfabrik Reinhausen 2014 31222/08 EN TAPCON® 240
If external transport damage is detected on receipt of the shipment, proceed
as follows:
Immediately record the transport damage found in the shipping docu-
ments and have this countersigned by the carrier.
In the event of severe damage, total loss or high damage costs, immedi-
ately notify the sales department at Maschinenfabrik Reinhausen and
the relevant insurance company.
After identifying damage, do not modify the condition of the shipment
further and retain the packaging material until an inspection decision
has been made by the transport company or the insurance company.
Record the details of the damage immediately onsite together with the
carrier involved. This is essential for any claim for damages!
If possible, photograph damage to packaging and packaged goods. This
also applies to signs of corrosion on the packaged goods due to mois-
ture inside the packaging (rain, snow, condensation).
Be absolutely sure to also check the sealed packaging.
When damages are not determined until unpacking after receipt of the ship-
ment (hidden damage), proceed as follows:
Make the party responsible for the damage liable as soon as possible by
telephone and in writing, and prepare a damage report.
Observe the time periods applicable to such actions in the respective
country. Inquire about these in good time.
With hidden damage, it is very hard to make the transportation company (or
other responsible party) liable. Any insurance claims for such damages can
only be successful if relevant provisions are expressly included in the insur-
ance terms and conditions.
Storage of shipments
When selecting and setting up the storage location, ensure the following:
Protect stored goods against moisture (flooding, water from melting
snow and ice), dirt, pests such as rats, mice, termites and so on, and
against unauthorized access.
Store the crates on timber beams and planks as a protection against ris-
ing damp and for better ventilation.
Ensure sufficient carrying capacity of the ground.
Keep entrance paths free.
Check stored goods at regular intervals. Also take appropriate action af-
ter storms, heavy rain or snow and so on.
Visible damage
Hidden damage
4.3

Table of Contents

Other manuals for MR tapcon 240

Related product manuals