SW
12
Innovation. Quality. Performance. Best in Industry. Worldwide.
MultiCam Software
The MultiCam software installation CD contains the MultiCam motion controller software, which provides
the interface between the computer and the
MultiCam Laser. The installation CD also contains machine
schematics, software drivers, and a routing guide that contains cutting tips. Before installing the
MultiCam
software, customers should make sure there are no other applications open on the computer. Internet Explorer
v5.5 or newer is required for this installation.
A. Insert the MultiCam Installation CD into the CD-ROM drive. This will normally cause the computer to read
the CD and then direct the customer through the commands for installation.
B. Follow these steps if the installation does not start automatically:
1. Select the Windows Start button at the bottom left of the screen.
2. Select Run.
3. Select Browse on the Run Dialog box.
4. Select the MultiCam Installation Folder from the directory.
5. Select Setup.Exe.
6. Select Open.
7. Select OK on the Run dialog box.
8. Follow the setup menus for a complete installation of the
MultiCam software. Software
Motion Controller Utilities
The MultiCam software was developed to allow the operator more options and to interface with the newer
Windows software. In addition to supporting the DNC function, the
MultiCam software also has options for
digitizing, as well as a file Previewer, Job Reporter, bar code scanning, and tool diameter compensation. These
tools are all written in 32-bit code and run directly from Windows 2000 or higher.
PSS Suite 4
JobServer
MotionMechanic
JobNameServer
MotionMechanic
JobPreviewer
Machine Connections
JobEditor
ConnectionManager
JobReporter
JobReporter
JobConsole
Software
Routers * Lasers * Plasma * WaterJets * Knife Cutters
www.MultiCam.com v. 11 10
To Next Page
Loading...