User’s Guide – Ultima cutting plotter
36 AP-75032, Rev 2.2, 20/04/07
3.2.2. Speed selection
To change / control the cutting speed, please perform the instructions mentioned bow.
Step 1 : Press the [SPEED] key.
Step 2 : The actual SPEED setting for the selected tool will now be shown on the display. Viewing of the
value can be performed in PAUSE as well as in READY mode.
Speed
Actual : 10
New : 10
In cm/s
Notes
Changing/viewing of the value can be performed in BUSY mode. Please note that the effect can only be
seen after a few seconds.
Notes
Toolup / laser speed is independent of the cutting speed.
Step 3 : Press the [UP] or [DOWN] key to change the force setting.
Step 4 : Press the [ENTER] key to confirm the SPEED selection.
Notes
To cancel the changes of the parameter, press the [CANCEL] key. The display will show the previous
value for the parameter.
When you press the [EXIT] key the changed value will be ignored and you go back to the previous menu.
3.2.3.
Offset selection
One of the most important factors to obtain good quality, but unfortunately also one of the factors that is
easily forgotten, is the offset.
For more information about the offset, please refer to the chapter ‘Fine-tuning your cutter to obtain Mutoh
quality’.
To Next Page
Loading...
