MUTOH Ultima - Sheet off Mode

User’s Guide – Ultima cutting plotter
52 AP-75032, Rev 2.2, 20/04/07
4.2.1. Sheet Off Mode
With the sheet-off mode, you can select “AUTOMAT”, “MANUAL” or “DISABLE”.
Automatic A sheet-off can be done when pressing the “Exit-Sheet OFF” key.
Manual A sheet-off can be done with a snap-off blade knife; the paper will feed towards the cutgroove.
Disable No sheet-off can be done
The auto-sheet-off mechanism of your cutter can be very easily used to cut the front edge of a new roll of
vinyl straight as well as to cut off a sheet of vinyl from a roll, to be used as a separate sheet. Please refer to
2.11.
To perform sheet off, proceed as follows:
Step 1 : In the general setting select ‘Sheet Off Mode’ by using the [UP] or [DOWN] key.
Step 2 : Press the [ENTER] key to confirm your selection. The actual Sheet Off Mode will now be shown
on the display
Sheet Off
Actual : AUTOMAT
New : AUTOMAT
Sheet Off Mode
Step 3 : By using the [UP] or [DOWN] key select “Automat”, “Manual” or “Disable”.
Step 4 : Press the [ENTER] key to confirm.
Notes
To cancel the changes of the parameter, press the [CANCEL] key. The display will show the previous
value for the parameter.
When you press the [EXIT] key the changed value will be ignored and you go back to the previous menu.
Notes
When pressing the [EXIT-SHEET OFF] key for a while, following message will appear.
Do a sheet off?
▲ = No
▼ = Yes
This message will only appear when Sheet Off Mode is enabled.